Ok, so I decided to play something on Dingux today, so I obviously booted my Dingoo and held select.

It opened the text console and wrote all that text it usually does, but then the screen suddenly started to flash very annoyingly.

I had to reset it by pinning the hole, and tried again. Again it got stuck and the screen started flashing.

This is the last part of the text that remained on the screen after it froze:

mininit 1.0.0 by Ignacio Garcia Perez
Mounting /proc /sys /dev
Reading kernel command line
Mounting /dev/mmcblk0p1 on /boot
Setting up loopback /dev/loop0 /boot/rootfs
FATAL: cannot open /boot/rootfs (2)
Kernel panic - not Syncing: Attemepted to kill init!

I have to say that it was very annoying trying to read the small font while the screen flashed so much lol.

I believe that it somehow conflicts with the Homebrew Channel for the Wii that I installed on the same SD card a few days ago, since before that it never showed any problems. So, is there any solution that allows me to have both the HBC and Dingux on the same card, or will I need to purchase a separate card? Thanks in advance for the dingux experts here.

As an additional info, I also have obviously nearly all the HBC software on the card, I was just wondering if just deleteting the Wii-linuxes would help. If so, where to find them? I'm not really sure about that since I just used the homebrew downloader to download all the stuff, it placed the software on the SD cards by itself, so I have no clue where the software are.