That looks interesting... I think that's the one I saw at BEST BUY recently.  Unfortunately, both sides of the "hard shell" seemed to be caved in already, and with only the zipper between them, I didn't think it would offer much crush resistance.  No matter how hard the sides of a case are, the fact that there's only a zipper between them means that any force exerted on the outside just squishes the halves of the shell together, with the poor Dingoo inbetween.

The other problem I have with that case is the elastic strap... it's fine for hard drives or a DS, etc. but with the Dingoo the screen is exposed and would be right under that strap.  It's probably soft enough to not do any damage, but I'd just hate to think that when the case gets squished it's rubbing that strap on my screen HARD.

I might take a look at the official case, but for now I've given up and gone the DS route.  I bought the DS Lite/DSi mini folio at Walmart for about $9, and it works pretty well.  Granted any DS case is a bit roomy for the Dingoo, but I would caution everyone that a PSP case (even for the 3000) is going to be too wide where the system goes, leaving the Dingoo sliding around all the time... NOT good if the screen isn't protected!  Obviously a PSP Go case isn't wide enough.

The DS mini folio has a nice pocket for the system instead of a strap, and doesn't really have a lot of extraneous features.  The system pocket holds the Dingoo nicely -- whereas the DS Lite would stick out a bit, the pocket completely protects the Dingoo.  The two stylus holders are extraneous of course, but that would be a good place to store that much-needed paper clip. ;)  There is a flap with pockets for 6 DS games, and that of course would be great for mini-SD cards, although who would need 6 of those I don't know.  The mesh pocket is great for the USB cable and maybe some earbuds, but I wouldn't put the AC plug in there because it's gonna get squashed against the system if the case takes any weight from the outside.

I would also advise against "play-in-the-case" cases because even though ones for the DS Lite should hold the Dingoo well, it will cover the power button as well as the Start and Select buttons.

So far I'm delighted with my A320, and I'm happy to be joining the Dingoo community! :)

Hey im looking for a good, sturdy case that i could easily strap to my belt. It would also be nice if i could easily remove it from the case without taking the case off my belt. Any Suggestions?

Pretty much any case for a game boy (unless its for the SP or original) works good w/ dingoo, that's what I use.

This is the exact same case I bought, a few days after my dingoo arrived.

I must say, it's the perfect little case, strong, and i know i don't really have to worry when the dingoo is in that thing in my backpack.

Is there a way to transfer a dingoo programing from one dingoo to the other?

I have crazy issue. I have two dingoos.

One has a broken r button but runs dingux!

The other dingoo has a working R button but i cant seem to flash dingux on it. It has some strange issue where it says firmwarE failure and it wont run dingux. it seems  to a rising issue amgonst new dingoo owners.

JUST AS NOTE OF WHAT I HAVE DONE TO THE DINGOO WHO CANT RUN DINGUX, YES I HAVE REFLASHED THE ORGINAL FIRMWARE USING BOTH RECOVERY TOOL AND DUAL BOOT, YES HAVE USED BOTH INSTALL METHODS, ONE  FROM COMPLETE IDIOTS GUIDE TO INSTALLING DINGUX AND THE USBTOOL.EXE METHOD, AND YES I HAVE THE CORRECT LCD IMAGE AND NEWEST DUAL BOOTER, i HAVE FLASHED  MY CARD MUTIPLE TIMES, AND REFROMATED THEM AND EVEN USED DIFFERENT CARDS. 

IF YOU WANT TO SEE PICTURES GO HERE TO THIS FORUM FROM ANOTHER PERSON WHO HAS SAME ISSUE 

http://a320.freeforums.org/post9424.html#p9424

BUT MY REAL QUESTION IS "IS THERE A WAY TO TAKE MY DINGOO'S (THAT RUNS DINGUX) SYSTEM PROGRAMING TO TRANSFER IT TO MY NEW DINGOO (THAT DOESNT RUN DINGUX)? BASICALLY TRADE OUT ITS FIRMWARE AND SYSTEM CONFIG! OR IS THERE A EASY WAS TO TRANSFER R BUTTONS?

Anybody got some dealextreme suggestions for a hard case?

Thanks got mine tody everything fits in the case :)

that looks like it could be a good buy, i've been carrying my Dingoo in a bobble wrap enelope..

for UK users i found this case on ebay for £9 including free delivery. will be buying one next pay day.

cgi.ebay.co.uk/ws/eBayISAPI.dll